#1806502scBadBox (Reg $139.95 READ ALL) IN STOCK in 1:18 scale is the YANKEE PEDDLER as driven by Bill Flynn. It's the 1st actual 1965 Dodge Sedan AWB 1:18 die cast drag car replica that has been made (notice the "wide rear pillar" body). Developed by Supercars President Scott Dahlberg (aka MR. MOPAR) just as ALL the 1:18th AWB Dodges and Plymouths have been. These are 11.25" long, and extremely detailed with real metal hood pins, lift off hood, tall fuel injection stacks, real metal brake line from master cylinder, and the fuel tank up front on the grille. Of the 1,050 made as a Limited Edition for Supercar Collectibles, only 954 are for distribution here in the USA. The beige single seat interior almost looks real with the seat belts, built in dash gauges, pushbutton shift, and roll bar. These have the correct "piecrust" slicks, plus see the "parachute pull cable" inside the car? This car IS that detailed. NOTE #1: The trunk lid "pins" are not installed, but are wrapped in a small tightly wrapped bag - taped on the white Styrofoam clamshell packaging. Be VERY careful installing them so you don't scratch the paint. China did not install them, and we have no idea why. In addition to a die cast body, this also has an actual die cast chassis too, and real metal leaf springs. Also has opening trunk, big truck battery, and battery cables. Produced by ACME especially for us, using the Die Cast Promotions / Highway 61 tooling. NOTE #2: We have a few here with a minor crunch in a back corner of the box, and the cars is just fine. Sold "as is" no return. If you want to save some money - get one here and now!